GEFEN EU

Extenders >> Extenders for HDMI >> Extender for HDMI ELR with PoL over CAT5 (Discontinued)


 

 

 




User Application:The de-embedder allows the user to extract audio to be monitored,
recorded, or broadcasted from an SDI audio/video stream. During a live broadcast,
the de-embedder can be used to extract audio from the SDI feed to master before it
goes out to broadcast.



This product has been discontinued and replaced by the:

Gefen 4K Ultra HD ELR-POL Extender: EXT-UHD-CAT5-ELRPOL


Extend HDMI Ultra HD 4K x 2K and 1080p Full HD up to 330 feet (100 meters) over a single CAT-5 cable with Ethernet, RS-232, IR, remote 5V DC Power


The GefenPRO Extender for HDMI ELR with PoL over CAT5 extends a HDMI source with 1080p Full HD video and high-resolution multi channel audio up 330 feet (100 meters) using a single CAT-5e cable. The receiver unit also has the ability to power a separate 5V DC device at up to 2 amps using power transmitted over the CAT-5 cable. This product also extends Ethernet, and provides an IR back channel to allow control of remotely located AV sources from the display location, all through the same single CAT-5. DVI-D is also supported through the use of a HDMI to DVI adapter, providing greater flexibility when integrating various types of sources and displays.

 

 

 

 

 

 

How It Works

 

The GefenPRO Extender for HDMI ELR with PoL over CAT5 system consists of Sender and Receiver units. The Sender is located next to the HDMI source, and the Receiver is installed near the remote HDMI display. The source and the Sender are connected with the included 6 foot HDMI cable, and the Receiver and the Display are connected with a user supplied cable. A single CAT-5e cable of up to 330 feet (100 meters) in length links the Sender and Receiver units. The Ethernet ports on both the Sender and Receiver units are connected to standard network devices such as 100Base-T routers and hubs, and can also be connected to Ethernet equipped sources and displays. The Sender unit is powered by an internal power supply and provides power to the Receiver over the CAT-5e cable. An additional 5V/2A DC Gefen device can be powered from the receiver using the optional power cable listed below. In addition, IR commands can be relayed from the display location to the source component(s) with the optional Gefen IR accessories listed on the left-hand side of the page. Note:  * Power over Line (PoL) is a Gefen proprietary technology that provides 10W of 5 Volt DC power to the Receiver Unit over the single CAT-5 signal cable, and allows the Receiver Unit to power additional Gefen devices.

It is based on the Power over Ethernet (PoE) Standards, but is specifically tailored to Gefen's Hi-Def video products.


Features
  • Extends 4K Ultra HD (3840 x 2160 @ 60Hz, 4:2:0 or @ 30Hz, 4:4:4:), Ethernet, RS-232, and Bi-Directional IR over a single CAT-5e cable up to 330 feet/100 meters (8-bit color
  • Extends 4K Cinema (DCI) (4096 x 2160 @ 24 or 30Hz 4:4:4), Ethernet, RS-232,  and Bi-Directional IR over a single CAT-5e cable up to 330 feet/100meters (8-bit color
  • Extends HDMI at 1080p Full HD, Ethernet, RS-232, and Bi-Directional IR over a single CAT-5e cable up to 330 feet/100 meters (up to 12-bit Deep Color)
  • Supported HDMI features:
    • HDMI 2.0
    • HDCP 2.2 and 1.4
    • 12-bit Deep Color
    • LPCM 7.1 audio, Dolby® TrueHD, Dolby Digital® Plus, and DTS-HD® Master Audio™ pass-through
    • 3DTV pass-through
    • CEC pass-through
    • Lip Sync pass-through
  • Power over Line: Using Gefen POL technology, the Receiver unit is powered from the CAT-5 cable, and offers one +5V 2A output to power additional devices
  • IR back-channel to control any source equipment from the remote location
  • RS-232 extension
  • ELR and HDBaseT™ technologies allow extension up to 330 feet (100 meters)
  • Extends 100BaseT Ethernet to the remote location
  • Internal power supply at the Sender unit
  • +5V output with locking connector at the Receiver unit
  • Rack-mountable (using Gefen EXT-RACK-1U)
Specifications
  • Maximum Pixel Clock: 300MHz
  • Maximum TMDS Clock: 300MHz
  • Video Input Connector (Sender): (1) HDMI Type A 19-pin, female
  • Video Output Connector (Receiver): (1) HDMI Type A 19-pin, female
  • RS-232 Connector (Sender): DB-9, female
  • RS-232 Connector (Receiver): DB-9, male
  • Ethernet Connector (Sender / Receiver): RJ-45, Shielded
  • Link Connector (Sender / Receiver): RJ-45, Shielded
  • IR Extender Input (Receiver): 3.5 mm mini-stereo jack
  • IR Extender Type (Receiver): EXT-RMT-EXTIR (available separately)
  • IR Emitter Output (Sender): (1) 3.5 mm mini-mono jack
  • Power Supply (Sender): 100 - 240V AC (Internal)
  • Power Input Connector (Sender): IEC inlet with fuse-holder and power switch
  • Power Indicator (Receiver) : LED, Red
  • Operating Temperature: 32 °F to +113 °F (0 °C to +45 °C)
  • Storage Temperature: -4 °F to +140 °F (-20 °C to +60 °C)
  • Humidity: 20% to 90%RH, no condensation
  • Dimensions (Sender / Receiver) (W x H x D): 8.3" x 1.7" x 6.7" (210mm x 43mm x 170mm)
  • Shipping Weight: 8 lbs (3.6 kg)

Optional Accessories  show

 

 

 



 

 

Purchase Options

 

Additional Power Cable Options:      Quantity:         Price:    $1,299.00
This product has been discontinued.



SKU:   GEF-HDCAT5-ELRPOL

UPC:   845344033563









 

 

 

HDMI, the HDMI Logo, and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries.